Kb-electronics KBDA-42 Bedienungsanleitung PDF herunterladen (Seite 43)

APPENDIX A – OPTIONAL IODA INPUT/OUTPUT MULTI-FUNCTION BOARD

he IODA Input/Output Multi-Function Board pr

ovides a variety of functions, which include preset frequen-

cy, up/down frequency control, signal isolation, isolated output voltage for controlling auxiliary devices,

open collector outputs, and output relay contacts. The IODA mounts on the drive’s PC board with 2 snap-

ins (located on the bottom of the mounting base) and 2 screws (provided). All of the IODA inputs and out-

puts are isolated from the AC line.

The IODA has a green power on LED (PWR) and a red status LED (STATUS), which are used to provide

operational information of the IODA. See Table 10, below, for a description of the IODA status indicator

LED. See Figure 24, on page 43, for the IODA layout. See Figure 25, on page 43, for the IODA Terminal

Block TB1 Layout. See Table 11, on page 43, for the IODA Terminal Block TB1 Wire and Tightening Torque

Specifications. See Table 12, on page 44, for the IODA Functions and Features. See Sections A1 – A7, on

pages 45 – 49 describing the use of the IODA Multi-Function Input Terminals for Remote Operations. See

Sections A8 – A12, on pages 49 – 54, for Other Functions and Features of the IODA.

Local/Remote Operation – When using the IODA with signal following, it may be appropriate to program

the drive for Local/Remote Operation. In this mode, the drive fr

equency setting can be toggled between a

ocess signal and the keypad using the JOG-LCL/REM Key. Set Jog-Local/Remote (Function No. 2.02) to

Jog Disabled; Local/Remote Enabled (“0002”) to change the JOG-LCL/REM Key from Jog Operation to

Local/Remote Operation.

IODA Faults – External Fault T

rip (“EF–t”) indicates that a Multi-Function Input T

erminal (Function Nos.

7.00 – 7.06 set to “0008”) has closed (and will change the state of the Multi-Function Output Relay

Contacts and the Multi-Function Open Collectors (when Function Nos. 8.00 – 8.03 are set to “0007”)).

Current Source Trip (“CS–t”) indicates that the current signal output (from the IODA) has been opened.

Communication Error (“Err4”) indicates that communication between the drive and the IODA has failed.

WARNING! Do not depend on the LEDs or the 4-Digit Display to no longer be illuminated as a

guaranteed power of

f condition. Be sur

e the main power switch or circuit breaker is in the “OFF”

position before servicing the drive.

TABLE 10 – IODA STATUS INDICATOR LED

Condition Red STATUS LED

Normal Operation Not Illuminated

Communication Error

Flashes 1 Second On and 1 Second Off

Current Source Trip

Illuminated

Notes: 1. When a Communication Error occurs, the drive’s 4-Digit Display will show “Err4”. 2. When a Current Source

Trip occurs, the drive’s 4-Digit Display will show “CS-t”.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 56 57

Keine Kommentare

Kb-electronics KBDA-42 Bedienungsanleitung Seite 43